Sylvania 6900DTE - Manual (Page 21)

21
EN
1A23
Other Connections
4 Other
Connections
D. AU D I O O U T
C O A X .
L P b
P r
L
R
1 2
Y C V B S
O U T
C O M P.
O U T
A N T.
C T L
D. AU D I O
O U T DV I COMP.
DV I - D H D C P O U T OPT
S - V I D E O
O U T
RESOLUTION
SELECT
1 0 8 0 i / 7 2 0 p / 4 8 0 p
A N T. I N
AU D I O O U T
e.g.: Connection to VCR
Rear panel of STB
VCR
Video cable
Video
cable
Audio
cable
To video input
jack
To audio input
jacks (L, R)
NOTE:
Audio and Video cables are not included.
Audio cable
STB connection to TV and Video devices (VCR, DVD recorder, etc)
1 Refer to "Antenna Connections" to connect the STB to the Smart Antenna (or a different one if you wish).
2 Use a standard audio cable to connect the AUDIO OUT jacks (L, R) on the STB to the audio input jacks (L,
R) on the VCR.
NOTE:
If your VCR is monaural (MONO) and has only one audio jack, use a standard audio cable (white) to connect the
AUDIO OUT jack (white) on STB to the audio input jack (white) on the VCR. The red cable and jack will not be
used.
3 Use a standard video cable to connect the CVBS OUT jack (Composite) on the STB to the video input
jack on the VCR.
4 Use a standard video cable to connect the video output jack on the VCR to the video input jack on the TV.
5 Use a standard audio cable to connect the set of audio output jacks (L, R) on the VCR to the audio input
jacks (L, R) on the TV.
6 Plug all AC power cords into AC outlets, then turn all devices on.
7 Set the TV and VCR to input mode.
Refer to your television’s or VCR’s manual for details.
NOTE:
When using this connection, the resolution of the video signal output will always be 480i.
ST300UA.qxd 04.8.3 1:12 PM Page 21