Onkyo HT-RC370 - Manual (Page 33)

33
En
Error Messages
While Audyssey MultEQ ® XT Room Correction and
Speaker Setup is in progress, one of the error messages
below may appear.
The options are:
`
Retry:
Try again.
`
Cancel:
Cancel Audyssey MultEQ XT Room Correction and
Speaker Setup.
• Ambient noise is too high.
The background noise is too loud. Remove the source of
the noise and try again.
• Speaker Matching Error!
The number of speakers detected was different from
that of the first measurement. Check the speaker
connection.
• Writing Error!
This message appears if saving fails. Try saving again.
If this message appears after 2 or 3 attempts, contact
your Onkyo dealer.
• Speaker Detect Error
This message appears if a speaker is not detected. “No”
means that no speaker was detected.
Tip
• See “Speaker Configuration” for appropriate settings
(
➔
page 13).
Changing the Speaker Setup Manually
You can manually make changes to the settings found
during Audyssey MultEQ XT Room Correction and
Speaker Setup.
See also:
• “Speaker Configuration” (
➔
page 46)
• “Speaker Distance” (
➔
page 47)
• “Level Calibration” (
➔ page 48)
• “Equalizer Settings” (
➔
page 48)
Note
• Please note that THX recommends any THX main speakers be
set to “80Hz(THX)”. If you set up your speakers using
Audyssey MultEQ XT Room Correction and Speaker Setup,
please make sure manually that any THX speakers are set to
“80Hz(THX)” crossover (
➔
page 46).
• Sometimes due to the electrical complexities of subwoofers and
the interaction with the room, THX recommends setting the
level and the distance of the subwoofer manually.
• Sometimes due to interaction with the room, you may notice
irregular results when setting the level and/or distance of the
main speakers. If this happens, THX recommends setting them
manually.
Using a Powered Subwoofer
If you’re using a powered subwoofer and it outputs very
low-frequency sound at a low volume level, it may not be
detected by Audyssey MultEQ XT Room Correction and
Speaker Setup.
If the “Subwoofer” appears on the “Review Speaker
Configuration” screen as “No”, increase the subwoofer’s
volume to the half-way point, set it to its highest crossover
frequency, and then try running Audyssey MultEQ XT
Room Correction and Speaker Setup again. Note that if
the volume is set too high and the sound distorts, detection
issues may occur, so use an appropriate volume level. If
the subwoofer has a low-pass filter switch, set it to Off or
Direct. Refer to your subwoofer’s instruction manual for
details.
Retry
Cancel
Ambient noise is too high.
MultEQ XT: Auto Setup
AUDYSSEY
Error message