Olympus E-100 - Manual (Page 26)

CONNECTING TO EXTERNAL EQUIPMENT
E-125
1. Use the video cable to connect the camera to
the television as shown in the illustration.
2. Perform the required operation on the TV to set
it up for video input.
• See the documentation that comes with your televi-
sion for information about how to do this.
3. Perform normal playback and recording opera-
tions on the camera.
IMPORTANT!
• Icons and other indicators that normally appear on the
camera’s monitor screen will also appear on the
screen of the connected TV.
Selecting the Video Output Signal Mode
Your camera supports both NTSC (used in U.S., Japan, and
other countries) and PAL (used in Europe and other areas)
video output signal systems. The video system you should
use depends on the country of origin of the equipment you
are connecting to the camera’s VIDEO OUT terminal.
IMPORTANT!
• When you have PAL selected as the video signal out-
put mode, the monitor screen is turned off when you
connect the cable to the VIDEO OUT terminal.
1. Align the POWER/Function Switch with REC or
PLAY.
2. Press MENU.
3. Select “VIDEO OUT” using one of the following
two key operations, and then press SET/DISP.
4. Use [
̄
] and [
̆
] to select “NTSC” or “PAL”,
and then press SET/DISP.
If you are here
REC mode
PLAY mode
Select this on the menu screen
“FUNCTION” “SET UP” “VIDEO OUT”
“SET UP” “VIDEO OUT”