Omega Vehicle Security TCIC - Manual (Page 24)

TCIC User’s Manual
22
3.2.3 Library
There is a ‘settings library’ on the PC disk in which all settings may
be stored - both Card Settings (section 3.2.2.1) and TCIC-Monitor
Settings (section 3.2.2.2). The library files reside in the subfolder
TCIC_Lib under the installation folder, for example:
C:\Program Files\IMS\TCIC-MONITOR\TCIC_Lib
3.2.3.1 Load
Loads a setting set from the library.
Once you want the loaded set to take effect, click the ‘Save Settings
& Exit’ button. As long as you don’t click that button, the
previous
set remains in effect.
3.2.3.2 Save
Saves the current setting set into the library.
3.2.3.3 Delete
Deletes a setting set from the library.
3.3 "Outputs" Box
This box both describes the status of the 8 outputs, and enables to
manually change their status. Just click to invert output status. Note
that an output is sometimes accessible for manual change and
sometimes not, depending on the selection of Output Mode and the
actual value of the output:
* Output Mode = ‘Manual’: Output is accessible for manual change.
* Output Mode = ‘SP-Auto’: Output is not accessible for manual change.
* Output Mode = ‘SP-Latch’: Output is accessible only in order to turn it off.
In other words: The output can be turned on
only by the card, and turned off only manually.