Oracom ULTRA MAX 695 - Manual (Page 15)

4
12
2
4, 3
6
5
7
22
2a
A
13
22a
Fig. 14
Note: Filter &
Displacement Pump
not shown
16
C
B
26
1 Torque to 80 in-lb (9 N
m)
1
1
41
25
9665A
309067 15
Drive Housing, Connecting Rod, Crankshaft
NOTE: Inspect parts as they are removed. Replace
parts that are worn or damaged.
1.
Relieve pressure; page 3.
2. Remove displacement pump. See page 11.
3. Remove shroud (32).
4. Lower heat sink (22) and remove pressure trans-
ducer (67). See page 16.
4
Fig. 13 7840A
16
5. Remove three drive housing screws (16) and
lockwashers (4). Also see Fig. 14.
6. Remove two motor screws and lockwashers (3, 4).
See Fig. 14.
CAUTION
Do not allow gear (13) to fall; gear may stay attached
to the drive housing or to the motor.
Do not lose the thrust balls (2a or 41) or let them fall
between the gears, which will damage the drive
housing if not removed. The balls, which are heavily
covered with grease, usually stay in the gear re-
cesses, but could be dislodged. If the balls are not in
place, the bearings will wear prematurely.
7. Tap lower rear of drive housing (2) with a plastic
mallet to loosen motor. Pull drive housing straight
off motor.
8. Remove and inspect crankshaft (5) and connecting
rod (12). Replace all damaged or worn parts.
9. Install connecting rod.
10. Lubricate inside of connecting rod bearing with
SAE non-detergent oil. Pack roller bearing and
gears with grease supplied.
NOTE: The gears and bearings between the drive
housing (2) and motor front end bell (C) should contain
a total of 3 fl oz (89 cc) of grease.
11. Place large washer (6) and then small washer (7)
on crankshaft (5).
12. Rotate crank to top of stroke and insert crankshaft
(5). Align gears and push drive housing (2) straight
onto motor and locating pins. Install screws (16, 3)
and their lockwashers (4). Torque to 80 in-lb (9
N

m).
13. Plug in pressure transducer. See page 16.
14. Install displacement pump. See page 11.
15. Install front cover (11).
16. Replace shroud (32).
17. Replace heat sink (22).