Omega Engineering FLR1000 - Manual (Page 4)

pg. 4 of 29
A. Introduction
1. Unpacking
All units are suitably packaged to prevent damage during shipping. If
external damage is noted upon receipt of the package, please contact
Omega Engineering immediately.
Open the package from the top, taking care not to cut too deeply into the
package. Remove all the documentation and contents. Take care to
remove all the items and check them against the packing slip. The
products should also be checked for any concealed shipping damage. If
any shortages or damage is noted, please contact the shipping company
and/or Omega Engineering to resolve the problem.
Typical Contents of Box:
Sensor, Calibration Certificate & Instruction Manual
(Model FLR 1000 shown, other models similar).
Caution: Take care not to drop your sensor or subject it to
sudden impact. Read the installation section of this manual
before providing power or tubing connections to the unit. Any
damage caused by improper installation or careless handling will
not be repaired under warranty (see limited warranty on page
28 for more details).
2. Product Overview and Principle of Operation
The FLR 1000 series of flow meters and sensors for gases from Omega
Engineering are capable of measuring volumetric flows as low as 20-100
ml/min or as high as 100-500 l/min. Highly repeatable results are
achieved using a patented Pelton Turbine Wheel flow sensor design. This
FLR 3100/3100BR/3100ST
Series
Fl S & M t F