Onkyo HT-S5200 - Manual (Page 74)

74
Advanced Setup
—Continued
Dolby EX Input Signal Setting
Dolby EX Auto: When the source is Dolby EX, you can select the Dolby EX listening mode.
Manual: When the source is Dolby EX, you can select any of the listening modes compatible
with this format (e.g., Dolby EX, Dolby Pro Logic IIx, etc.) (default).
This setting determines how Dolby EX encoded signals are handled. This setting is unavailable if no surround
back speakers are connected. This setting is effective with Dolby Digital, Dolby Digital Plus and Dolby TrueHD
only.
Audyssey Settings
After room correction and speaker setup is completed, Audyssey Dynamic EQ™ becomes “On” by default.
Dynamic EQ Off: Audyssey Dynamic EQ off.
On: Audyssey Dynamic EQ on (default).
With Audyssey Dynamic EQ, you can enjoy great sound even when listening at low volume levels.
Audyssey Dynamic EQ solves the problem of deteriorating sound quality as volume is decreased by taking into
account human perception and room acoustics. It does so by selecting the correct frequency response and
surround volume levels moment-by-moment so that the content sounds the way it was created at any volume
level--not just at reference level.
Notes:
• Audyssey Dynamic EQ allows you to maintain the proper octave-to-octave balance at any volume level in
accordance with the speakers.
• In order to record with appropriate sound, Audyssey 2EQ™ is automatically deactivated during a recording.
After the recording is finished, Audyssey 2EQ and Audyssey Dynamic EQ will resume as previously set.
• “Dynamic EQ” and “Dyn Vol” become available (see page 74).
Dyn Vol (Dynamic Volume)
Off: Audyssey Dynamic Volume™ off.
Light: Light Compression Mode becomes active (see page 39).
Medium: Medium Compression Mode becomes active (see page 39).
Heavy: Heavy Compression Mode becomes active. This setting affects volume the most,
causing all sounds to be of equal loudness.
Notes:
• Other than “Off”, “Dynamic EQ” becomes “On”, and “6. Equalizer” (see page 72) setting becomes
“Audyssey”.
• “Dynamic Volume” becomes active when Dynamic EQ is set to “On”. Therefore, it is “Off” forcibly if
“Dynamic EQ” becomes “Off”.
T-D (Theater-Dimensional) Setting
LstnAngl (Listening Angle)
Wide: Select if the listening angle is 40 degrees (default).
Narrow: Select if the listening angle is 20 degrees.
With this setting, you can optimize the Theater- Dimensional listening
mode by specifying the angle of the front left and right speakers relative
to the listening position. Ideally, the front left and right speakers should
be equidistant from the listening position and at an angle close to one of
the two available settings.
20°/40°
Front left
speaker Front right
speaker
HT-S5200_En.book 74 ページ ２００９年３月９日 月曜日 午後４時３１分