Troubleshooting —continued – Onkyo HT-S5200 User Manual

Page 87

Advertising
background image

87

Troubleshooting

—Continued

The following settings can be made for the
composite video inputs
You must use the buttons on the unit to make these
settings.
1. While holding down the input selector button for the

input source that you want to set, press the [SETUP]
button.

2. Use the Left and Right [

]/[

] buttons to change

the setting.

3. Press the [SETUP] button when you’ve finished.

• Video Attenuation

This setting can be made for the DVD/BD,
VCR/DVR, CBL/SAT, or AUX input.
If you have a games console connected to the
composite video input, and the picture isn’t very
clear, you can attenuate the gain.
Video ATT:0: (default).
Video ATT:2: Gain is reduced by 2 dB.

The AV receiver contains a microcomputer for signal
processing and control functions. In very rare situations,
severe interference, noise from an external source, or static
electricity may cause it to lockup. In the unlikely event that
this happens, unplug the power cord from the wall outlet,
wait at least 5 seconds, and then plug it back in again.

Onkyo is not responsible for damages (such as CD
rental fees) due to unsuccessful recordings caused by
this unit’s malfunction. Before you record important
data, make sure that the material will be recorded
correctly.

Before disconnecting the power cord from the wall
outlet, set the AV receiver to Standby.

HT-S5200_En.book 87 ページ 2009年3月9日 月曜日 午後4時31分

Advertising