Ohlins CANNONDALE FG 9910 - Manual (Page 12)

12
e
f
d
Notes Fasten the fork leg, at the fork
bottom, with soft jaws in a
vice.
Install the compression valve
assembly in the fork bottom.
Tightening torque 45 Nm.
Apply some front fork oil on
the outer surface of the inner
leg, and push the outer leg up
and down a few times.
Measure the correct amount
of oil according to the specifi-
cation card.
First, fill up the cartridge tube,
then raise up the outer leg
about 250 mm and add the
remaining oil.
Install the fork top cap and the
lock nut.
Tighten the top cap and the
lock nut against each other,
use a 16 and 24 mm wrench.
Fit the fork legs on the motor-
cycle.
For tightening torques, please
see your bike's work shop
manual.
Adjust the compression- and
the rebound valves according
to the specification card.
Install the damper rod assem-
bly into the cartridge tube.
Use Lotite 542 on the car-
tridge top lid.
Tighten with tool 1797-01.
Tightening torque 40 Nm.
Pump the damper rod up and
down a few times to check
that there is no air left.
Pull out the damper rod as far
as possible and close the
compression- and the rebound
valves.
Install the spring and the
preload spacer.