Ohlins CANNONDALE FG 9910 - Manual (Page 9)

9
e
f
d
Changing springs
Loosen the screws that hold
the fork legs in the
upper fork
crown.
With the fork leg still tightened
in the
lower fork crown unscrew
the top cap, use a 24 mm
wrench.
Loosen the screws that hold
the fork legs in the lower fork
crown.
Remove the fork legs from the
motorcycle.
Fasten the fork leg with soft
jaws in a vice and loosen the
lock nut on the top of the fork
cap.
Remove the top cap from the
damper rod extender, use a 16
and 24 mm wrench.
Remove the spring support, the
preload washer and the spring.
For free spring length see tech-
nical information on page 13.
NOTE
Closing the compression- and
the rebound valves will keep the
damper rod extended making it
easier to install the new spring.
Pull out the damper rod as far
as possible.
Close the compression and the
rebound valve (
clockwise).
Install the spring and the
preload washer.
Install the spring support fork
top cap and the lock nut.
Tighten the top cap and the
lock nut against each other, use
a 16 and 24 mm wrench.
Adjust the compression- and
the rebound valves according
to specification card.
Fit the fork legs on the motorcy-
cle.
For tightening torques, please
see your bike's work shop
manual.