OxiBrands 1/4" 18 Gauge Crown Air Stapler 68018 - Manual (Page 14)

Page 14 For technical questions, please call 1-800-444-3353. SKU 68018
3. Hold the Stapler pointed away from you
and any other people or fragile objects
and lift up the Cover Latch (43).
4. Pull up on the Switch, lifting the Cover
Plate (44) up off the Drive Guide (41)
and remove jammed fasteners.
5. Inspect Drive Guide for bends or
breakage. If it is damaged, do not use
tool until it is repaired by a qualified
technician.
6. Lightly oil Drive Guide and replace the
Cover Plate (57).
7. If a fastener is jammed in the Magazine,
unfasten the Latch and slide the Nail
Guide Frame out all the way back. Use
a screwdriver to release the jammed
fastener by probing the openings in the
Guide.
8. Pull out the jammed fastener and the
remainder of the fastener strip that is
still in the magazine. Dispose of the
remaining fastener strip; it may be bent
or damaged in some other way.
9. Reload the Stapler.
10. Reconnect the Stapler to the air hose.
11. Press the Safety Tip against an
appropriate piece of scrap wood and test
fire the Stapler several times, checking
for proper operation.
12. Disconnect Stapler, remove the staples,
and store the Stapler in a location out of
children’s reach.
13. If you are unable to clear the fastener
jam using the method prescribed above,
the tool should be taken to a qualified
service technician for proper servicing.