OxiBrands 1/4" 18 Gauge Crown Air Stapler 68018 - Manual (Page 7)

Page 7 For technical questions, please call 1-800-444-3353. SKU 68018
FUNCTIONAL DESCRIPTION
Specifications
Maximum Air
Pressure
120 PSI
Air Inlet 1/4”-18 NPT
Fastener
Type
5/8” to 1-5/8”, 18 Gauge, 1/4”
Crown Staples
Magazine
Capacity
100 Pieces
Safety Single Sequential
Components and Controls
Safety Nosepiece - Also called the workpiece
contact, the Safety Nosepiece helps
prevent the tool from firing unless it is
pressed against an object.
INITIAL SET UP/ASSEMBLY
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
Note: For additional information regarding the
parts listed in the following pages, refer
to the Assembly Diagram near the end of
this manual.
Unpacking
When unpacking, make sure the item
is intact and undamaged. If any parts are
missing or broken, please call Harbor Freight
Tools at 1-800-444-3353 as soon as possible.
• This air tool may be shipped with a
protective plug covering the air inlet.
Remove this plug before set up.
Air Supply
TO PREVENT
EXPLOSION:
Use only clean, dry, regulated,
compressed air to power this
tool. Do not use oxygen, carbon
dioxide, combustible gases, or
any other bottled gas as a power
source for this tool.
1. Connect a regulator valve, an in-line shut
off valve and 1/4” NPT air hose (all sold
separately) to the Quick Coupler. Use
thread tape on all threaded connections.
The air hose must be long enough to
reach the work area with enough extra
length to allow free movement while
working. An in-line shutoff ball valve
is an important safety device because
it controls air supply even if air hose
is ruptured. The shutoff valve should
be a ball valve because it can be
closed quickly. See pages 8 and 9 for
Air Tool Setup procedures.
Note: If an automatic oiler system is not
used, add a few drops of Pneumatic
Tool Oil into the airline connection before
operation. Add a few more drops after
each hour of continual use.
2. Attach air hose to compressor’s air
outlet. Connect air hose to air inlet of
Trigger
(32)
Safety (37)
Air Deflector (3)
Air Inlet
Plug (72)
Latch
(63)
Functional Description
Initial Tool Setup/Assembly