Orion 20VROT - Manual (Page 23)

21
LOADING AND UNLOADING THE VIDEO CASSETTE TAPE
Use only video cassette tapes marked .
Push the centre of the tape until it is automatically inserted.
AUTOMATIC POWER ON AND PLAY
When loading a cassette tape without the erase prevention tab intact, playback will start immediately and the
TV will turn on.
Insert the cassette with its labelled side facing you.
An inverted cassette cannot be inserted.
LOADING
UNLOADING
To unload a video cassette, press the EJECT button
on the remote control, or press the STOP/EJECT
button on the TV/VCR twice. The first press will stop
the tape in any mode. The second press will eject
the tape.
EJECT
AUTOMATIC EJECT
When the VCR is automatically rewinding the tape and
reaches its end (AUTO REWIND), the tape will be ejected
automatically. (See NOTE on page 26.)
OR
Pull the cassette out.
After recording, break off the erase prevention tab if
you do not wish to record over the tape. Cover the hole with vinyl tape.
Be careful the tape does not extend past the edges of
the cassette housing.
TO RECORD AGAIN TO PREVENT ACCIDENTAL ERASURE
VIDEO CASSETTE TAPE
TAPE SPEED AND MAXIMUM RECORDING/PLAYBACK TIME
TAPE SPEED
SP (Standard Play )
LP (Long Play)
E-300 E-60 E-180 E-240 E-90 E-30
30 minutes 1 hour 1-1/2 hours 3 hours 4 hours 5 hours
1 hour 2 hours 3 hours 6 hours 8 hours 10 hours
NOTES: • Always eject the tape when not in use.
• The cassette can be ejected even if the POWER button is OFF.
STOP/EJECT