Onkyo DV-SP506 - Manual (Page 29)

29
Connecting the Power/Turning on the DV-SP506
Before connecting
• Make sure that all the connections on pages 18–28 are
complete (the connection to a TV is required).
Note:
• The DV-SP506 features a screen saver and an auto
power off function. If the DV-SP506 is stopped and no
button is pressed for 15 minutes, the screen saver starts
(see page 56). If the disc tray is closed but no disc is
playing and no control is pressed for 20 minutes, the
DV-SP506 automatically goes into standby (see
page 58).
You can adjust the brightness of the display as follows.
Note:
• When the display brightness is changed, the display
brightness of other Onkyo AV components connected
via
also changes. This does not work for compo-
nents connected via RIHD.
1 Plug the supplied power cord into
the AC INLET and then into the
power outlet on the wall.
• Do not use a power cord other than the
one supplied with the DV-SP506. The
power cord supplied is designed for
use with the DV-SP506 and should not
be used with any other device.
• Never have the power cord discon-
nected from the DV-SP506 while the
other end is plugged into the wall out-
let. Doing so may cause an electric
shock. Always connect by plugging
into the wall outlet last and disconnect
by unplugging from the wall outlet
first.
• Before unplugging the DV-SP506
from the power outlet, make sure you
first switch it into standby.
RETURN SETUP
TOP MENU MENU CU RSOR
PU SH TO ENTE R
ON/STANDBY
ON STANDBY
STANDBY indicator
• For the above reasons, do not plug the
DV-SP506 into a switched power sup-
ply found on some amplifiers and AV
receivers.
2 Press [ON/STANDBY] button on
the DV-SP506 or [ON] on the
remote controller.
Turn on your TV and select the
input through which the DV-SP506
is connected.
The DV-SP506 turns on and the
STANDBY indicator turns off.
• To put the DV-SP506 in the standby
mode, press [ON/STANDBY] on the
DV-SP506, or [STANDBY] on the
remote controller.
• While the STANDBY indicator lights
up, the DV-SP506 can receive signals
from the remote controller.
• Setting the [ON/STANDBY] button to
standby does not shut off the power
completely.
Adjusting the Display Brightness
1 Press the [DIMMER] button
repeatedly to cycle through the
following options:
Dim, dimmer, or normal.
To a wall
outlet
ANDBY ST
ON/STANDBY
Remote
controller