Oki PM4410 - Manual (Page 27)

E-25 Pacemark 4410 Setup Guide
The printer is set to a default front-feed paper width of 13.6
inches (136 columns). If you are using 9-inch paper, you
must enter the printer menu and change the setting to 8
inches (80 columns) to avoid printing on the platen and
damaging the printhead. Other paper widths must be set
using your software application.
To change the menu setting to 8 inches, turn the printer on,
then:
a. Press MENU.
b. Press GROUP until Front Feed appears on the display.
c. Press ITEM until Page Width appears on the display.
d. Press OPTION once to switch to the 8-inch setting.
An asterisk (*) appears next to the setting.
e. Press STORE to save the 8-inch setting.
f. Press MENU to exit the menu mode and save the new
setting.
The Top of Form (TOF) for the front feed paper path is set at the
factory to 0.35 inch (9 mm) down from the top of the page. If this
setting does not suit your application, you will need to set the Top of
Form: see “Setting Top of Form” in the Front Panel Overview section
of this Setup Guide.