Oki PM4410 - Manual (Page 59)

E-57 Pacemark 4410 Setup Guide
Adjusting the Tear-Off Position
The tear-off positions for the front and rear paper paths are set
independently.
To adjust the tear-off position for the paper currently in the paper path:
• Hold SHIFT (1) and press FF/LOAD/Micro Feed Up (2) repeatedly
to move the continuous forms up
• Hold SHIFT (1) and press LF/Micro Feed Down (3) repeatedly to
move the continuous forms down.
Paper Park Feature
When you press PARK (1), the continuous forms currently in the print
path retract out of the path and are placed in the parked position
(remaining loaded on the tractors, ready to feed in again) and the
ALARM light comes on.
To reload the forms, press FF/LOAD.
To load the forms from the alternate paper path, press PATH/TOF.
1
1
2
3