Oki C3520 - Manual (Page 76)

Operation > 76
Starting Fax send
When the Enter Fax no. screen is open, press the Start
button after entering a Fax no. to start sending the Fax.
Or you can return to the Fax Stand-by screen by pressing
the Enter key after entering a Fax no., and start sending
the Fax by pressing the Start button.
Continuing/completing selecting a Fax Send destination
When you complete entering a Fax no. the Continue
screen appears.
In the Continue screen, move the cursor to Continue and
press the Enter key to return to the Enter Fax no. screen.
In the Continue screen, move the cursor to Done and
press the Enter key to return to the Fax Stand-by screen.
When you return to the Fax Stand-by screen after
selecting a Fax no., you will see Confirm below the Fax
no. and the cursor on Confirm.
Adding a Fax destination
Select a Fax no. in the Fax Stand-by screen and add it.
F
AX
R
ECEIVING
Automatic Fax receive. (default mode)
When the MFP is in Automatic Fax Receive, the screen display
appears only in the Idle state. The display does not appear during
operation. If Fax receiving fails, the error display message
remains until you press the Stop button.
When Automatic Fax Receive is functioning correctly:
When ringing - Receiving Start is displayed on screen
While it is receiving a Fax - Fax Receiving, sender's Fax
no., and the number of received pages are displayed until
the reception of data from all pages is completed.
Upon completion of Fax Receiving, sender's Fax no., the
total number of received pages, and Receiving OK are
displayed for 3 seconds, and the display changes to the
Mode Selection screen.