Quantum ATL M-Series - Manual (Page 75)

Chapter 3 Changing the Library Configuration
Changing a Tape Drive ID
ATL M-Series User’s Guide 57
To change a tape drive SCSI ID:
1 Access the Configuration screen (see Accessing the
Configuration Screen ).
2 Press the Up or Down buttons until the desired drive ID (for
example, Drive 1 ID ) is highlighted.
3 Press Select .
4 Use the Up or Down buttons to select the desired SCSI ID.
Available settings are 0 through 15 and Disabled .
5 Press Select .
To return to the Configuration screen without changing the
option setting, press Cancel .
6 If desired, repeat steps 2 through 5 to set the SCSI ID for
another tape drive.
7 Press Main to return to the main screen.
Caution: Set the drive SCSI ID to
Disabled
only if the
drive is not installed in the library.
Caution: If you do not return to the main screen after
changing this setting, your change will not be
saved to NVRAM.
Note: You must reboot the library before this setting will
take effect.