Tru-Test Electric Fence Security System - Manual (Page 8)

8
Alarm Response
If the electric fence security system is breached, it triggers an alarm — the security siren and any
auxiliary equipment, such as a master alarm system/tele-dialler, are activated.
After activation, the cause of the alarm is indicated by the Fence and Gate lamps (on the case front
of the Compact, the Keypad, and Keyswitch). Whenever the cause of alarm is present, the
appropriate lamp will also flash.
After a programmed period (say, 3 minutes) the siren is automatically switched off, but any
auxiliary equipment remains activated until the system is disarmed.
After the alarm siren has switched off automatically, the electric fence security system will remain
active and be ready to raise the alarm again if necessary. Each subsequent activation of the alarm
will normally cause the siren to be re-triggered.
The siren can be silenced immediately by the user, without deactivating the electric fence security
system. This can be done using the Keyswitch or Keypad.
Silencing the siren and turning off auxiliary equipment
Silencing the siren and turning off auxiliary equipment using the Keyswitch
First silence the siren:
1
Insert the key into the Keyswitch.
2 Rotate ¼ turn to the right until a fast beeping is heard.
3 Return the key back to the upright position and remove.
Then disarm the unit and deactivate auxiliary equipment:
•
Repeat steps 1-3.
Silencing the siren and turning off auxiliary equipment using the Keypad
First silence the siren:
• Enter the UPIN or OPIN, then press :
COMMAND
KEY
1
KEY
2
KEY
3
KEY
4
KEY
5
Silence using
User PIN U P I N
or
Owner PIN O P I N
Then disarm the unit and deactivate auxiliary equipment:
•
Repeat the step above.