TAG MIL-BOOK 200 - Manual (Page 89)

5-10 Setup Configuration Utility (SCU)
LPT Port
This item configures the parallel port of the computer.
Port Address sets the I/O address and the Interrupt ReQuest line
settings of the parallel port. The options are None; LPT1, 378, IRQ7;
LPT2, 278, IRQ5; and LPT3, 3BC, IRQ7.
Port Definition sets the operating mode for the parallel port
according to the type of the parallel device to be connected. Your
system supports EPP (Enhanced Parallel Port) and ECP (Extended
Capabilities Port) standards, which turn the standard parallel port
into a high-speed bi-directional peripheral port. The options are
Standard AT (Centronics), Bidirectional (PS-2), Enhanced Parallel
(EPP), and Extended Capabilities (ECP). This item is not valid for
setting if the Port Address item is set to None.
MC97 Controller
Enables or disables the system’s support for PCI modem device. A check
mark ( ) indicates enabled; an underline (_) indicates disabled.