Getting started, Warning – Technicolor - Thomson DPL680 User Manual

Page 12

Advertising
background image

Getting Started

EN

9

Test Tone / Channel balance

Channel balance

Your receiver is equipped with a test signal generator
for balancing the channels. As the signal "travels" from
channel to channel, adjust the level controls until each
channel plays at the same loudness level.

To activate and adjust test tone, refer to “Testing
Speaker Loudness” under the “Advanced Sound
Control” section (Pg 20).

Level adjustment & surround channel
level expectation

Even though you adjust the surround channel to be as
loud as the others on the test signal, you'll find that on
actual program material the surround channel is usually
much lower than the front. Don't be tempted to
readjust the surround level; program producers use
surround mostly for subtle atmospheric and ambience,
and only rarely for special effects. A good surround mix
doesn't call attention to itself; if it did, it would soon
become distracting.

Factory Setting

The unit is preset to the following settings when you
first power the receiver up right out of the box:
Function = TUNER
Volume setting = 25
Bass & treble = 0 dB
EQ = FLAT
Speaker settings: Center, surr = YES

Subwoofer = STRONG

DRC = OFF

Reset to Factory Settings

You may restore factory setting with the following
procedures:
1. Enter SAT mode.
2. Press PRESET UP, PRESET DOWN, SOURCE to

reset the unit.

All preset stations will reset to FM87.5MHz and all
receiver settings restore to default settings as described
above.

NOTE

The system is equipped with Dolby Digital,
and manufactured under License from Dolby
Laboratories.

Manufactured under license from
Dolby Laboratories. “Dolby”, “Pro
Logic” and the double-D symbol are

trademarks of Dolby Laboratories. Confidential
Unpublished Works. © 1992-1997 Dolby Laboratories,
Inc. All rights reserved.

Courtesy Dolby Laboratories

NOTE

STRONG SUBWOOFER setting makes the
output level of subwoofer speaker to be
stronger than normal Dolby setting. Adjust
the SUBWOOFER setting by pressing the
SUBWOOFER key to achieve the best bass
performance.

Manufactured under license from
Digital Theater Systems, Inc. US Pat. No.
5,451,942, 5,956,674, 5,974,380,
5,978,762 and other world-wide patents

issued and pending. "DTS" and "DTS Digital Surround"
are registered trademarks of Digital Theater Systems,
Inc. Copyright 1996, 2000 Digital Theater Systems, Inc.
All Rights Reserved.

WARNING

All preset radio stations and surround
sound settings will be lost after factory
setting is restored.

DPL680 EN 4/8/04 4:00 PM Page 13

Advertising