Technicolor - Thomson DPL680 - Manual (Page 18)

Operating your Receiver
EN
15
Using the receiver to play a source
After having properly connected a source (DVD, CD,
VCR) to the receiver, you can partly control them
through the receiver.
Playing a DVD with the receiver
1. Connect a DVD player to the receiver (see connecting
your receiver for details).
2. Press ON/ECO on the main unit or press on the
remote control to switch on the receiver.
3. Press the SOURCE button repeatedly on the main
unit or DVD•6 CH on the remote control to select the
DVD source.
4. Switch ON the DVD player and start playback.
5. Switch ON your TV.
6. Select the appropriate A/V channel on the TV (refer
to your TV manual for details) until the image from
the DVD player is displayed.
7. Set the Surround Mode if needed (see "Advanced
sound control" for details).
Example 1:
To play Dolby Prologic II Movie sound
Press the SURROUND buttons until "Dolby PL II
MOVIE" appears on the Display and all of the
speaker'’ icons light up.
Example 2:
LD: You may need to select a different Audio Channel
on your LD (refer to your LD player manual).
8. Adjust the volume knob accordingly.
NOTE
To play Dolby Digital sound, the source must be
connected to the receiver via the optical or
coaxial input terminal
NOTE
To receive VCR signal for recording, you must
connect analog outputs from DVD/CD/SAT/TV to
the analog inputs of the receiver.
NOTE
Some DVD players may require you to set the
digital output format to get Dolby Digital and
DTS signals through digital connection to the
receiver.
DPL680 EN 4/8/04 4:01 PM Page 19