Getting started, Inserting batteries into remote control, Set up and maintenance of the receiver – Technicolor - Thomson DPL680 User Manual

Page 6: Protect your components from overheating, Using headphones

Advertising
background image

Getting Started

Inserting Batteries into Remote Control

Install batteries as follows:
1. Remove the battery compartment door by applying

thumb pressure on battery door and then lift the
door out and off the cabinet.

2. Insert 2 “AAA” (R03) batteries into the battery

compartment according to the + and - signs in the
compartment and replace the compartment door.

3. To use the remote control, point it directly at your

receiver.

Set up and Maintenance of the Receiver

Provide spaces for sufficient ventilation as indicated:

• Do not connect to the AC power cords until all

connections are completed.

• Do not use your set immediately after transferring it

from a cold place to a warm place: there is risk of
condensation.

• Do not expose your set to water and excessively high

temperatures.

• After having disconnected your set, clean the case

with a soft cloth, or with a slightly damp leather
chamois. Never use strong solvents.

Protect your Components from
Overheating

• Do not block ventilation holes in any component.

Arrange the components so that air can circulate
freely.

• Do not stack components directly on top of each

other.

• Do not place the unit near other components that

generate heat such as heating vents.

• Allow adequate ventilation when placing your

components in a stand.

• Place an amplifier near the top shelf of the stand so

heated air rising from it will not affect other
components. If you have a satellite receiver, you
should place it on the top shelf.

Using Headphones

To listen privately through your audio
system, use the PHONES jack on the
receiver. However, make sure you
turn down the volume before you
put on the headphones. Increase the
volume to the desired level after
headphones are in place.

Once headphones are connected, “HEADPHONE DOWN
MIX 2 CHANNEL” will scroll on display. This feature
automatically converts multi-channel speaker outputs to
2 channel stereo for your listening pleasure.

Hearing Comfort & Well-Being

• Do not play your headset at a high volume. Hearing

experts advise against continuous extended play.

• If you experience a ringing in your ears, reduce

volume or discontinue use.

EN

3

10 cm/4"

5 cm/
2"

10 cm/4"

10 cm/
4"

10 cm/
4"

Front View

Side View

DPL680 EN 4/8/04 4:00 PM Page 7

Advertising