Tascam CD-RW402 - Manual (Page 23)

4 – Playback operations—Using the jog function
TASCAM CD-RW402 Owner’s Manual
23
Searching inside tracks
Using the main unit While in play or play ready
mode, pressing and holding the search keys on the
main unit will move the playback position forwards
or backwards by a small amount.
Pressing and releasing the keys will move the play-
back position backwards and forwards by one minute
at a time.
Using the remote control unit The track skip
keys on the remote control unit can be used for small
movements of the playback position (similar to
pressing and holding the search keys) if they are
pressed and held for more than one second.
Using the jog function
The jog function allows you to set the playback posi-
tion precisely, to frame accuracy (75 frames=1 sec-
ond). This can be useful when copying or playing
back only a selected part of the disc, or editing the
TOC so that precisely selected portions can be
deleted or extracted.
Jogging takes place in play or pause mode, and
works in the following way:
1 Position the playback point at approximately
the position at which the jogged playback
position will be.
2 Press the appropriate JOG key. The JOG
indicator lights and the display shows the
current playback position including the
frame value (for example,
0:45:13 ).
3 Turn the MULTI DIAL (or use the skip keys on
the remote control unit). The displayed play-
back position moves backwards or forwards
(depending on the direction in which the dial
is turned or on the skip key pressed). The
“preview portion” of the track, immediately
before the new playback position, is
repeated.
Turning the dial faster increases the rate at
which the position is moved (turning it
slower moves it by only one frame per click).
4 Continue to turn the dial or use the skip keys
until end of the jogged preview portion
reaches the desired playback point.
5 Press the JOG key so that the indicator goes
out. The drive enters pause mode at the point
at the end of the preview portion.
Once the playback position has been set in this way
in ready mode, it can be used as the
A or B point or as
the call point (see “Cue point” on page 22).
NOTE
If shuffle or programmed playback is selected and jog-
ging takes place as described above, the play mode
reverts to the normal “continue” mode.
Changing the preview portion length
1 Press either MENU key. Turn the MULTI DIAL
until the display shows PLAY MENU ? .
2 Push the MULTI DIAL .
3 Turn the MULTI DIAL until the display shows
JOG LENGTH ? .
4 Push the MULTI DIAL .
5 Turn the MULTI DIAL to set the length of the
preview portion in frames, from 12 frames
through 99 frames.
6 Push the MULTI DIAL .
Playback modes
The unit can be set to play back the whole disc in the
order in which it was created, the tracks of the disc in
a random (shuffled) order, or a programmed order.
This can be done either using the remote control or
the main unit.
Using the remote control
1 Press the appropriate P.MODE key repeat-
edly to cycle the display through the follow-
ing: