Tascam CD-RW402 - Manual (Page 24)

4 – Playback operations—Repeat playback
24
TASCAM CD-RW402 Owner’s Manual
• SHUFFLE (random track order). In this mode, each
track is played once before the disc repeats. Using
the track skip functions will move backwards or
forwards through the random order, e.g. if track 7 is
followed by track 10, it is possible to use the track
skip keys to go back to track 7, which is remem-
bered as being before immediately before track 10.
The red
SHUFFLE display indicator lights in this
mode.
• PROGRAM (see “Programmed order playback” on
page 24 below). The red PROGRAM display indica-
tor lights in this mode.
• CONTINUE Normal playback mode. Programming is
cancelled, and playback continues in the normal
order.
The selected mode is shown in large characters on
the display. It disappears from the display a few sec-
onds after selecting the mode, and the display returns
to its previous mode.
Using the main unit menu system
1 Press the appropriate MENU key.
2 Turn the MULTI DIAL until PLAY MENU ?
appears in the display. Push the MULTI DIAL .
3 Turn the MULTI DIAL until PLAY MODE?
appears in the display. Push the MULTI DIAL .
4 Turn the MULTI DIAL . The three options
detailed above are shown as PMODE>SHUF ?
(shuffle), PMODE>PGM ? (programmed play-
back) and PMODE>CONTI? (continue playback).
5 Push the MULTI DIAL when the appropriate
option is displayed.
Programmed order playback
The steps to set up to 99 program steps (tracks) to be
played back in a specified order are as follows:
1 Set the play mode to Program as described
above.
2 The display changes to show
0 Tr 00:00 00 ,
meaning that no program steps have yet had
tracks assigned to them.
3 Set the switch on the remote control to let the
number keys control either drive 1 or drive 2.
4 Use the number keys on the remote control to
enter a track number (including the
+10 key
to enter values greater than 9, as described
above).
The track entered is assigned to the program
step, and the display changes, showing the
track number, the total time of the program
so far, and the step number, e.g.
2 Tr 14:56 03 .
5 The next program step can then be entered.
NOTE
Steps 4 and 5 above can also be carried out from the
main unit by turning and pushing the MULTI DIAL.
6 Repeat steps 4 and 5 above until the program
is complete.
7 Press the PLAY key to start playback at the
first program step.
The display shows the track, the current time
display, and the program step number.
While in programmed playback mode, using
the
skip keys or the MULTI DIAL moves back-
wards and forwards in the order set in the
program.
Use the READY key to halt playback temporarily or
the STOP key to stop playback of the program.
If the STOP key is used, when playback is restarted,
it starts from the first program step.
Clear the program by setting the Continue play mode.
The program is also cleared when the disc tray is
opened, and if the
STOP key is pressed when play-
back is stopped in programmed order mode.
The programmed play order is not memorized when
power is turned off.
If an attempt is made to enter more than 99 program
steps, the message
PGM Full ! appears on the display.
Repeat playback
The repeat playback function allows repeated play-
back of the whole disc (
ALL ), a single track ( 1 ) or
repeat off ( OFF ).
Using the remote control
1 Press the appropriate REPEAT key repeat-
edly on the remote control unit to cycle