T+A Elektroakustik SADV 1245 R - Manual (Page 27)

27
Menu Sound
In this menu the basic settings for the sound reproduction
are adjusted.
Night mode
Off The sound is reproduced with full dymanics.
The difference between loud and soft
passages may be very high.
On Sound reproduction with decreased dynamics.
Loud passages will be played at a lower
volume, during soft passages the volume is
increased a little bit, especially in the dialog
track. This mode decreases the difference
between extremely loud and soft sequences.
This sound mode is recommended, if
neighbours or other members of the family
should not be disturbed.
CD-Upsample
This submenu can be used to increase the sampling rate
for audio signals digitally right in the DVD decoder.
Note:
This function will not be active in multi channel playback
mode.
Attention:
Only if Upsampling 'OFF' is selected the advanced 
oversampling algorithms (see chapter Oversampling) can
be used with maximum effect. For this reason we
recommend to use the 'OFF' setting.
Clear-Voice
Increases the volume of dialogues for a better
comprehension.
Note: This function is avalable only if supported by the
disc.
Analog Output
Sets the operation mode of the analogue Stereo output of
the SADV 1245 R.
Stereo If stereo is selected multichannel sound
tracks are down-mixed to stereo and output
through the L/R front outputs of the main
analogue output.
Please
use this setting if your
SADV 1245 R is connected to a stereo
amplifier.
Dolby Surr Use this setting if your SADV 1245 R is
connected to a Dolby-ProLogic decoder.
Multichannel soundtracks will be output
through the front L/R outputs of the multi
channel analogue output of the SADV 1245 R
in a Dolby ProLogic downmix version.
3D sound This setting will produce an artificial vitual
surround signal which can be played back
through normal 2-channel stereo amplifiers.
Multi-channel
If this setting is selected, multi channel
soundtracks will be output through all
channels of the 5.1 multi channel analog
output of the SADV 1245 R. For this setting
a multi channel surround amplifiier with
an analogue 5.1 (7.1) multichannel input
is required (see wiring diagrams 1,2 and
4).
Vocal (Karaoke)
Allows the playback of multichannel Karaoke DVDs.
ON Karaoke channels are mixed to a normal stereo
signal. Music and vocal channels of the recording
are played back.
OFF The vocal channel of the recording is muted.