T+A Elektroakustik SADV 1245 R - Manual (Page 37)

37
    RS 232 connector
Control input for controlling the SADV 1245 R through a
serial RS232 interface.
    Mains input
The mains power lead is connected to this socket. For
details of a correct mains connection please read the
notes in the chapter 'Installation, Using the unit for the
first time, Safety notes'.
    SDI OUT (Serial Digital Interface - optional)
Professional digital video interface (can be retro-fitted).
The SDI connection to a video projector/monitor with SDI
input guarantees a lossless video transmission even over
long cable runs.
    YUV video output
This video output deliveres high quality YUV (P P
b
P
r
)
output signals. Use this output to connect a video
projector/monitor with YUV input.
Important Note:
! The YUV output can be set to „progressive scan“
operation with the P-Scan switch on the front
panel. In progressive mode full frames instead of
half frames are output by the YUV output. This
gives
a far better picture quality. The
monitor/projector used must be compatible with
progressive video ! (please refer to the manual of
the video monitor/projector)
    VIDEO OUT
Video output for TV sets, video recorders or other
equipment with standard composite (CVBS) video inputs.
    S-VIDEO OUT
Output socket for TV sets, video recorders or other
equipment with S-Video (S-VHS) video inputs.
    AV OUT (SCART)
Socket for for TV sets, video recorders or other
equipment with SCART audio/ video inputs.
This socket delivers additional to standard composite
(CVBS) video signals the high quality RGB component
video signals. To achieve the best possible video
performance, please select the RGB mode at your
TV/monitor if this device is capable of processing these
signals.
    ANALOG OUT
Stereo audio output for TV sets, video recorders or
surround decoders.