SENAO EnGenius EP-801 - Manual (Page 16)

~31~
b. Hear bi-bi-beep while the initiating handset
broadcast the base stations.
c. Start to speak the message to be broadcasted
once you hear the “beep” sound; the speakerphone
of the base will be opened up
d. Press the key to end the broadcasting.
Redial
A. From Handset
1. Press REDIAL (Left) softkey.
2. The LCD shows the last phone number dialed. To dial
this number, press key.
3. Use p or Key to scroll through the last 10
phone numbers dialed. Select and press key.
[Note] Intercom numbers (Handset ID) are not stored in
the last 10 numbers dialed log.
B. From Base
1. Press key, after hearing the dial tone, followed by the key,
the last dialed number will be dialed.
2. Or press key followed by key, the last dialed number will be
dialed.
Receiving a Telephone Call
A. Handset
1. When an incoming call arrives, the LCD will show the
caller ID message, and the ringer will ring or vibrate
unless the ringer has been turned off.
2. If the handset is on the charger cradle (ringer will be
temporarily switched to “Ring” if it has been set to
“Vibrate”), lift the handset and press
key to start
conversation.
~32~
Re: You can turn on the “Any Key Talk” from MENU -5-2
Notes:
1. You can press SILENT (Left) soft key if you choose to ignore
the call. Unlike turning off the ringer (from the handset menu),
the
SILENT key operation is valid only for the current call.
2. If Caller ID service is available, the LCD will display the
incoming call information. If the LCD shows “Private” or
“Unknown”, the caller’s information may have been blocked by
the caller or the originating phone company.
B. Base
1. When an incoming call arrives, the ringer will ring, the speaker LED will
flash.
2. Press the to answer the call.
Receiving an Intercom Call
A. Intercom Call from Handset
1. When an intercom call arrives (called from other
handsets, ex. Handset 12), the ringer will ring or
vibrate unless the ringer has been turned off. Press
to answer the intercom call.
2. If the handset is on the charger cradle (ringer will be
temporarily switched to “Ring” if it has been set to
“Vibrate”), lift the handset and start conversation.
3. If the handset is not on the cradle, press any key (except
and the
SILENT soft key) to answer.
Notes:
1. The LCD displays the caller’s Handset ID.
2. You can press the
SILENT (Left) soft key if you choose to ignore
the call. Unlike turning off the ringer the SILENT key operation is
valid only for the current call.
B. Intercom Call from Base
1. When an intercom call arrives (called from Base), the
ringer will ring or vibrate unless the ringer has been