Topcom Butler E300 - Manual (Page 15)

Topcom Butler ME300/Twin/Triple/Quattro 11
Topcom Butler E300/Twin/Triple/Quattro
ENGLIS
H
8 Register to a Topcom Butler E300 base
You can subscribe 4 handsets to one base unit. By default, each handset is subscribed as
handset 1 on the base unit upon delivery (base unit 1).
!!! You only need to subscribe the handset if:
•
The handset subscription has been removed from the base unit (e.g. for reinitialisation)
• If you want to subscribe a different handset to this base unit.
The below procedure is only applicable to a Topcom Butler E300 handset and base unit!!
Keep the Paging key on the base unit pressed for 4 seconds. During one minute the base
unit is in register mode and you must do the following to subscribe the handset:
Press Menu button ÆUse the button to scroll to ‘System’ and press Æ
Select ‘Register’ Æ Enter the base pin code (0000) and press . Enter the number of
the base unit you would like to subscribe the handset to (1-4) Æ The unit will start searching
for the base and when found it will register Æ If the pin is wrong, the handset will restart the
searching for the base Æ When the handset is registered, it will show the handset name and
at the right the handset number.
8.1 Selecting a base unit
You can switch your handset between different registered base units if you have registered
a handset to more then one base. You can manually select the base unit or automatically let
the handset choose the nearest base.
Press Menu button
ÆUse the button to scroll to ‘System’ and press Æ
Select ‘Select base. Æ Select ‘Auto’ or the base number (1-4) by the Up/Down /
keys and press .
8.2 Removing a handset
You can remove a handset from a base to allow another handset to be registered:
Press Menu button
ÆUse the button to scroll to ‘System’ and press Æ
Select ‘Delete HS’. Press OK and select the handset you which to remove (1-4) Æ Press
OK to confirm Æ Enter the pin code (0000) and press .
You can only remove existing handsets and others then the one you are
using.