Thermador MES301HS - Manual (Page 50)

50
Run Decalcify mode at specific intervals to ensure that the appliance continues to
operate properly. The 8 indicator will remind you.
The descaling process takes approximately 30 minutes.
Decalcify mode is not required if you only use softened water.
Note:
Operation of the appliance will be blocked if Decalcify is canceled. The appliance
cannot be operated again until after the first and second cleaning cycle to ensure
that no descaling agent remains inside.
Use only the powder descaler recommended by customer service to descale the
appliance.
USA: item no. 310 967 at www.thermadorĆeshop.com
Canada: For Atlantic provinces, Ontario or Québec, contact A.P. Wagner,
1Ć800Ć287Ć1627, www.apwagner.ca
For any of the Territories, Manitoba, Saskatchewan, Alberta or British Columbia,
contact Reliable Parts, 1Ć800Ć941Ć9217, www.reliableparts.ca
Other descaling agents can damage the appliance.
1. Mix 32 oz water and 1 packet powder descaler to produce a descaler solution.
2. Empty the water tank and fill it with the descaling solution.
CAUTION: Ą Do not let the descaling solution come in contact with the
control panel or other sensitive surfaces. If it does, immediately remove it
using water.
The oven cavity must be cooled down completely.
1. Press and hold ON/OFF until the appliance turns on.
2. Press DECALCIFY to select Decalcify mode.
3. Press START/STOP.
Decalcify mode starts. The light in the oven remains off.
A beep sounds after approximately 30 minutes. The 9 (fill water tank) symbol
appears.
1. Wash out the water tank thoroughly, fill it with water and slide it back in.
The < (empty evaporator dish) symbol appears.
2. Use the cleaning sponge provided to remove any water remaining in the
evaporator dish.
3. Press START/STOP.
The appliance starts the cleaning process.
After a short time, the < symbol appears for the second time.
1. Thoroughly wash out the cleaning sponge.
2. Use the cleaning sponge to remove any water remaining in the evaporator dish.
Decalcify
Descaling Agent
ř
Starting Decalcify Mode
Cleaning Cycle 1
Cleaning Cycle 2