Texas Instruments TI-84 - Manual (Page 287)

Chapter 12: Statistics 284
The top line displays list names. L1 through L6 are stored in columns 1 through 6 after a
memory reset. The number of the current column is displayed in the top-right corner.
The bottom line is the entry line. All data entry occurs on this line. The characteristics of
this line change according to the current context.
The center area displays up to seven elements of up to three lists; it abbreviates values
when necessary. The entry line displays the full value of the current element.
Using the Stat List Editor Using the Stat List Editor Using the Stat List Editor Using the Stat List Editor
Entering a List Name in the Stat List Editor Entering a List Name in the Stat List Editor Entering a List Name in the Stat List Editor Entering a List Name in the Stat List Editor
To enter a list name in the stat list editor, follow these steps.
1. Display the Name= prompt in the entry line in either of two ways.
• Move the cursor onto the list name in the column where you want to insert a list,
and then press
y 6. An unnamed column is displayed and the remaining lists
shift right one column.
• Press
} until the cursor is on the top line, and then press ~ until you reach the
unnamed column.
Note: If list names are stored to all 20 columns, you must remove a list name to
make room for an unnamed column.
The Name= prompt is displayed and alpha-lock is on.