Telenetics Sunrise Series Modular Nest - Manual (Page 16)

Part No. TEL–09949, Rev A
June 2001
Pre-Installation Information and Activities Page 16 of 34
Attaching Ferrite Beads (U.S.A., Canada, and Japan Only)
A cable with an attached ferrite is included in the accessory kit for U.S.A., Canada,
and Japan 326X Series Modem cards. In order to meet FCC Class A and CISPR
requirements, the ferrite side of the dial and leased line cables must be attached as
close to the backplane as possible (Figure 6).
.
Figure 6. Attaching Ferrite Bead to Cable
Removing Audio Cable Connectors From a Modem Backplane
For compliance with safety standards, audio connectors (for dial and leased line
connections) on the 326X Series Modem backplane are recessed approximately
4 cm behind the sheet metal on the backplane (Figure 7).
Figure 7. Releasing Backplane Audio Connectors
The ferrite side of the cable
should be located on the end
closest to the modem backplane.
Ferrites
DIAL LINE A
2W LEASE
DIAL LINE B
2W/4W LEASE
A8 A6 A4 A2
A9 A7 A5 A3 A1
B8 B6 B4 B2
B9 B7 B5 B3 B1
SLOT9 8 7 6 5 4 3 2