Teledyne 4220 - Manual (Page 111)

4220 Flow Meter
Section 5 Options and Accessories
5-3
telephone company will provide advance notice in order
for you to make the necessary modifications in order to
maintain uninterrupted service.
“If trouble is experienced with this equipment, please
contact the Teledyne Isco Customer Service Department,
(800) 228-4373 or, outside the U.S.A., call (402) 464-0231, for
repair and (or) warranty information. If the trouble is
causing harm to the telephone network, the telephone
company may request you remove the equipment from
the network until the problem is resolved.
“The following repairs can be done by the customer:
None.
“ T h i s e q u i p m e n t c a n n o t b e u s e d o n t e l e p h o n e
company-provided coin service. Connection to Party Line
Service is subject to state tariffs.
“When programming and/or making test calls to emer-
gency numbers:
“Remain on the line and briefly explain to the dispatcher
the reason for making the call.”
“Perform such activities in the off-peak hours, such as the
early morning or late evenings.”
5.1.4 Types of Service The 4200T Modem is compatible with standard telephone lines
and comes with a 12 foot cable. The cable connects the flow
meter's Modem connector to a standard telephone jack, type
USOC RJ11C, supplied by the phone company. You must mount
the flow meter within 12 feet of this jack.
We are required by the FCC to provide the following notice:
“This equipment generates and uses radio frequency
energy and if not installed and used properly, in strict
accordance with the manufacturer's directions, may
cause interference with radio and television reception.
There is no guarantee that interference will not occur in a
particular installation. If this equipment does cause inter-
ference to radio or television reception, which can be
determined by turning equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
• Reorient the receiving antenna on the televi-
sion.
• Relocate the unit with respect to the receiver.
• Plug the unit into a different outlet so the unit
and receiver are on different branch circuits.
• If necessary, consult the manufacturer or an
experienced radio-television technician for
additional suggestions.”