TechniSat AX1 - Manual (Page 10)

10
Within a channel table the channels can be selected as follows:
> with ten-key keypad, e.g.
ᕡᕢᕣ
- channel position 123
ᕡᕢ
(hold depressed) - channel position 12
ᕦ
(hold depressed) - channel position 6
ᕡ
(wait 3 s) - channel position 1
> with of the remote control or on
the ADR receiver
Channel numbers of unoccupied channel positions are ignored.
To be able to set all channels also without the remote control, the
keys on the device switch from FREE to DMX at the end
of the ta ble. On request, you can leave the FAV ta ble by
connecting the installation menu from E1 ... E7,“STANDBY”.
If a transmission station transmits two different channels (MONO_A
and MONO_B) instead of a stereo channel, the LED does not
lighten and the two channels can be received independently of
each other.
> with you can switch between the two MONO channels.
5.4 Kind of programme selection
Within the ADR system a fixed kind of programme which allows e.g.
only to call successively programmes of the same kind is assigned
to a channel.
The following kinds of programmes are differentiated:
Take into consideration that the kind of programme selection only
wor ks within the ta bles FREE and DMX. ASTRASTAR AX 1
automatically switches from the FAV table to the FREE or DMX table
during the kind of programme selection.
Within the kind of programme mode one kind of programme is
assigned to the numeral keys respectively.
> switch on the kind of programme mode with
> select the desired kind of programme using a numeral key
> switch to the next programme of the same kind of programme in
this table with , or the
respective numeral key.
> you can leave the kind of programme mode by pressing
repeatedly or by calling a FREE, DMX or FAV table.
classics country
pop special music
oldies regional
rock news
jazz general