TechniSat AX1 - Manual (Page 6)

6
3 Connections
3.1 Outdoor unit
If possible, try to use an outdoor unit with TWIN LNB to be able to
receive satellite TV channels and digital radio channels at the
same time, independent of each other. If you do not want to
receive TV and digital radio channels at the same time, you may
continue to use your V/H LNB (s. 3.3 Satellite TV receivers).
Connect the LNB input of the ASTRASTAR AX 1 with the LNB of your
receiving equipment using an adequate coax cable. If the LNB
input is overloaded the message “cable error” appears in the
display after switching on.
If there is a short-circuit on the LNB input, the ADR receiver switches
off (a “ticking” is heard). In both cases switch off the ASTRASTAR AX
1 using the mains switch and eliminate the error cause. Observe
also 4 “Installation”.
3.2 HiFi amplifier
Connect the audio analogue outputs of the ADR receiver
ASTRASTAR AX 1 with an adequate amplifier input of your HiFi
equipment (e.g. CD or AUX). Caution, the phono input is not
adequate!
Devices with digital inputs (amplifiers, DAT recorders etc.) you can
connect to the electrical digital output.
Corresponding connection ca bles you can buy from your
TechniSat sales representative.
3.3 Satellite television receiver
If you want to operate your ADR receiver and a satellite television
receiver with a V/H LNB connect the coax cable from the LNB input
of the satellite television receiver to the TV receiver connection of
the ADR receiver.
ADR ST 3004 S
HiFi
Outdoor unit:
TWIN-LNB
ADR
2-way distributor
external voltage supply
ST 3004 S
HiFi
Outdoor unit:
ISISAT A/B or
ISISAT A/B/C for
a single cable solution
You can also connect the ASTRASTAR AX 1 to an ISISAT serial
distribution. Please take into consideration that in this case not all
channels can be received.
ST 3004 S