Toshiba TEC B B-SX5T SERIES - Manual (Page 24)

2. PRINTER SETUP ENGLISH VERSION EO1-33036
2.9 Inserting the Optional PCMCIA Cards
E2-14
2.9 Inserting the Optional
PCMCIA Cards
When the optional PCMCIA Interface Board is installed into the printer,
there will be two PCMCIA slots available as shown in the figure below.
This allows the use of Flash Memory type Cards or I/O Cards such as
LAN Cards. The following paragraphs outline how to insert PCMCIA
cards.
1. Make sure that the printer’s Power Switch is in the OFF position.
2. Hold the PCMCIA Card so that the side with the model name faces
left. Insert the card into the proper slot until the Eject Button pops
out.
3. Slightly pull and fold the Eject Button upward.
4. The following PCMCIA cards can be used.
Type Maker Description Remarks
ATA Card
San Disk,
Hitachi
A card conforming to the
PC card ATA standard
----------
LAN Card 3 COM 3CCE589ET Series
Install into the slot (2)
only. (This card
installed into the slot
(1) will not work.)
Maxell EF-4M-TB
Maxell EF-4M-TB
Centennial
Technologies INC.
FL04M-15-11119-03
Read/Write
INTEL IMC004FLSA
Simple
TECNOLOGY
STI-FL/4A
Mitsubishi MF84M1-G7DAT01
PC Card KING
MAX
FJN-004M6C
Centennial
Technologies Inc.
FL04M-20-11138-67
PC Card FJP-004M6R
Flash Memory
Card (4 MB)
Mitsubishi MF84M1-GMCAV01
Maxell EF-1M-TB Flash Memory
Card (1 MB) Mitsubishi MF81M1-GBDAT01
Read (See NOTE.)
CAUTION!
1. To protect PC cards,
discharge static
electricity from your body
by touching the metal
cabinet of the printer
before touching the card.
2. Before inserting or
removing a PCMCIA
card make sure that the
printer’s power is turned
off.
3. Be sure to protect
PCMCIA Cards when not
in use by putting them
into their protective
covers.
4. Do not subject the card
to any shocks or
excessive force nor
expose the card to
extremes in temperature
or humidity.
5. The card may be
inserted into the slot
halfway even in the
wrong orientation.
However, the slot is
safety designed so that
the card will not seat
against the connector
pins.
Slot 2:
(I/O type cards such as
LAN cards)
Slot 1:
(Memory type cards only)
Eject Button
NOTE:
Reading a read-only-type flash
memory is possible if it has been
used on the TOSHIBA TEC
printer, such as B-472 and B-572.
CC
DC
AA
Model Name
Printed Side
Eject Button