Toshiba TEC B B-SX5T SERIES - Manual (Page 7)

1. PRODUCT OVERVIEW ENGLISH VERSION EO1-33036
1.1 Introduction
E1- 1
1. PRODUCT OVERVIEW
1.1 Introduction
1.2 Features
1.3 Unpacking Thank you for choosing the TEC B-SX5T series thermal printer. This
Owner’s Manual contains from general set-up through how to confirm
the printer operation using a test print, and should be read carefully to
help gain maximum performance and life from your printer. For most
queries please refer to this manual and keep it safe for future reference.
Please contact your TOSHIBA TEC representative for further
information concerning this manual.
This printer has the following features:
•
The print head block can be opened providing smooth loading of
media and ribbon.
•
Various kinds of media can be used as the media sensors can be
moved from the centre to the left edge of the media.
•
The strip module, ribbon saving module, and expansion I/O interface
board are provided on this printer as standard.
•
When the optional interface board is installed, Web functions such as
remote maintenance and other advanced network features are
available.
•
Superior hardware, including the specially developed 12 dots/mm
(306 dots/inch) thermal print head which will allow very clear print at
a printing speed of 76.2 mm/sec. (3 inches/sec.), 127.0 mm/sec. (5
inches/sec.), or 203.2 mm/sec. (8 inches/sec.).
•
Besides the optional Cutter Module, there are also an optional
PCMCIA Interface Board, LAN Interface Board, and the USB
Interface Board.
Unpack the printer as per the Unpacking Instructions supplied with the
printer.
NOTES:
1. Check for damage or
scratches on the printer.
However, please note that
TOSHIBA TEC shall have no
liability for any damage of
any kind sustained during
transportation of the product.
2. Keep the cartons and pads
for future transportation of
the printer.