Step 4: installing anti-tip device, Caution, Warning – Thermador PRDS304 User Manual

Page 12

Advertising
background image

STEP 4: INSTALLING ANTI-TIP DEVICE

personal injury.

CAUTION

PROPERTY DAMAGE

Contact a qualified installer or contrac-
tor to determine the proper method for
drilling holes through the wall or floor
material (such as ceramic tile, hard-
wood, etc.)

Do not slide the range across an unpro-
tected floor.

Failure to follow these instructions
may result damage to wall or floor
coverings.

WARNING

RANGE TIPPING HAZARD

All ranges can tip and injury could
result. To prevent accidental tipping
of the range, attach it to the wall, floor
or cabinet by installing the Anti-Tip
Device supplied.

A risk of tip-over may exist if the
appliance is not installed in accor-
dance with these instructions.

If the range is pulled away from the
wall for cleaning, service, or any other
reason, ensure that the Anti-Tip De-
vice is properly reengaged when the
range is pushed back against the wall.
In the event of abnormal usage (such
as a person standing, sitting, or lean-
ing on an open door), failure to take
this precaution could result in tipping
of the range. Personal injury might
result from spilled hot liquids or from
the range itself.

WARNING

ELECTRICAL SHOCK HAZARD

Use extreme caution when drilling
holes into the wall or floor. There may
be concealed electrical wires located
behind the wall or under the floor.

Identify the electrical circuits that
could be effected by the installation of
the Anti-Tip Device, then turn off
power to these circuits.

Failure to follow these instructions
may result in electrical shock or other

Tools Needed for Installation of Anti-Tip Device:
- Screwdriver, Phillips

- Hammer

- Drill, electric or hand

- Pencil or other marker

- Measuring tape or ruler

- Wrench, 7/16" (PRG Ranges only)

- 1/8" drill bit (wood or metal wall or floor)

- Wrench adjustable (PRG Ranges only)

- 3/16" carbide-tipped masonry drill bit (concrete or concrete block wall or floor)
- 3/16" anchors, drywall or concrete, 2 each (not required if mounting bracket is being attached to solid
wood or metal)

For all 30" and 36" ranges, an anti-tip device must be in-
stalled as per these instructions.

WARNING

ALL RANGES CAN TIP

INJURY TO PERSONS
COULD RESULT

INSTALL ANTI-TIP
DEVICES PACKED
WITH RANGE

• SEE INSTRALLATION

INSTRUCTIONS

Page 10

Advertising
This manual is related to the following products: