Topfield TF 5400 PVR - Manual (Page 38)

32 Service Search
When you switch to an service, if the service is
provided by a satellite other than current one,
it will take longer time than usual because the
antenna has to turn to its position.
To use DiSEqC 1.2, select the In-
stallation > Satellite Setting >
Motorized DiSEqC 1.2 menu.
At first you have to set the Mo-
torized DiSEqC 1.2
option to
Enable .
To get the correct position of your desired satellite, perform
the following steps:
1. Choose your desired satellite at the Satellite Name op-
tion.
2. Set the DiSEqC Command Mode to User.
3. Select the Goto command at the Motor Control menu.
Then the antenna will turn toward your selected satel-
lite with the position data that the digital receiver has.
4. If the receiving quality, which is displayed on the right
bottom on the screen, is not good, tune the antenna finely
with the commands of the Movement menu. If you select
the 2(E) movement command, the antenna will move
to the east by two degrees. At this time you had bet-
ter check the receiving quality of every transponder and
choose the best one at the Transponder (or Frequency)
option. It will be helpful to your fine tuning.