Tiger Products Co., Ltd CNH T6010-80 - Manual (Page 68)

ASSEMBLY
Assembly Section 2-36
CONTINUOUS DUTY SOLENOID SWITCH
Mount the solenoid switch, drill holes to match if necessary, in a dry and well protected area.
Secure as shown in the parts section with provided 3/8” x 1” capscrews, lockwashers, and hex nuts.
Route wires to and from the Continuous Duty Solenoid Switch as shown below.
A.) ORANGE 10 GA. wire from terminal (A) to +12V battery fusible link.
B.) RED 14 GA. wire from terminal (C) to tractor plug in cab.
C.) BLACK 14 GA. wire from terminal (B) to -12V battery post.
D.) RED 10 GA. wire from terminal (D) to switch box.
E.) RED 14 GA. wire from terminal (D) to temperature gauge. (optional).
(ASM-NH-0032)
COOLER MOUNTING - SIDE TANK
Mount the cooler mounting brackets on the top rear side of the side hydraulic tank.
Locate the bolt plates on the top of the tank and secure the appropriate cooler bracket to
the tank with the hardware provided. Attach the screen and cooler to the brackets. Refer
to the Parts Section to attach the hoses and adapters to the cooler.
(ASM-C-0092)