Thermador Char-Glo CGBD30RX - Manual (Page 11)

Page 9
SECTION 5: UNPACKING, MOVING AND PLACING THE UNIT
FIGURE 6 FIGURE 7A
FIGURE 7B
10. All barbecue models are supplied with a
pressure regulator that is packed with the unit.
The regulator is set for natural gas. For use
with propane, it must be converted. The
regulator will be located on the left rear
bottom of the unit. Using a flat blade
9. On all models, the bypass jet must be turned
clockwise with a small flat-bladed screwdriver
until fully seated to set proper low flow rate.
See Figures 8 and 9.
screwdriver, remove the cap on the top of the
regulator and turn the cap over so that the
letters LP are exposed. Make sure the spring
in the regulator remains in position. Re-attach
the cap to the regulator. See Figures 10 and
11, below.
FIGURE 8 FIGURE 9
TAPE