Thermador Char-Glo CGBD30RX - Manual (Page 7)

Page 5
SECTION 3: SITE PREPARATION
BUILT-IN INSTALLATIONS
All Char-Glo ® Outdoor Barbecues
are CGA and AGA approved.
Note: All height width and depth dimensions are shown in inches.
Determine a suitable location for the barbecue by taking into account exposure to wind and availability of gas and
electrical supplies. Exposure to wind should be minimized, as wind can adversely affect cooking performance. Insure
that the gas supply line and electrical supply are located in close proximity to the unit to keep connections to the
unit as short as possible and allow for installation and removal of the unit from the enclosure. Allow adequate area
around the unit for dissipation of smoke produced during cooking.
CLEARANCES (Refer to Figures 3 and 4)
CABINET PREPARATION
The models CGBD30, CGBD36 and CGBD48 are designed for easy installation into masonry enclosures. For
noncombustible applications, the barbecue drops into the opening shown in Figures 3 and Fig. 4, (below). A ledge
is required to support the barbecue from the bottom. Models CGBD36 and CGBD48 also require a ledge in the
center of the opening to support the middle of the unit. The supporting ledges must be level and flat. The counter
top should also be level.
It is recommended that ventilation holes are provided in the enclosure in the event of a gas leak. The installer-
supplied gas shut-off valve must be installed in an easily accessible location.
CharGlo ® Outdoor Barbecues
Model No. Overall Dimensions Cutout Dimensions
A B C D E F
CGBD30RX 24- 3 /
4
30- 7 /
16
26- 5 /
8
11- 15 /
16
29- 3 /
4
22- 3 /
4
CGBD36RX 24- 3 /
4
36 26- 5 /
8
11- 15 /
16
35- 5 /
16
22- 3 /
4
CGBD48RSBX 24- 3 /
4
48 26- 5 /
8
11- 15 /
16
47- 5 /
16
22- 3 /
4
CGBD48RX 24- 3 /
4
48 26- 5 /
8
11- 15 /
16
47- 5 /
16
22- 3 /
4
Figure 3 Figure 4
C
E
F
B
A
3" minimum for
hood clearance
to back wall
Cutout Dimensions for
30", 36" and 48" Built-in Units
D
F
E
OPENING FOR
ACCESS DOOR
➞
GAS
INLET
3" MINIMUM FOR
LID CLEARANCE
36"
12"
NON-COMBUSTIBLE
ENCLOSURE
12"
12"
Properly Grounded
3-Prong Receptacle
36
Center Support
Ledge for
CGBD36 and CGBD48