Thermador Char-Glo CGBD30RX - Manual (Page 12)

Page 10
11. If the barbecue will be used with an LP cylinder,
follow these steps:
C. The proper LP hose and regulator assembly
must be used. The Model LPHOSE is available
at your Thermador dealer. This assembly can
also be purchased locally providing it meets the
following specifications:
Hose length to be 24".
Regulator must be a high pressure, high volume
unit capable of supplying adequate gas flow
based on the input rating of the unit (refer to
Gas Consumption in Section 2).
The inlet connector on the LP regulator must
be compatible with the LP cylinder valve.
The hose and regulator assembly must be AGA
certified for use with LP gas in an outdoor
application.
B. Install supplied 1/2" NPT coupling on the end of
the manifold located at the left rear bottom of
the cooktop. See Fig. 1. Use a pipe sealant
approved for use with LP gases on all threads.
SECTION 5: UNPACKING, MOVING AND PLACING THE UNIT
C. Attach gas hose/regulator assembly to the
coupling as shown in Fig. 1.
D. Connect the gas regulator assembly to the LP
tank valve.
E. Attach gas regulator label (included with LP
orifices) to the gas regulator.
12. Turn on the gas supply but do not attempt to light
any burner. Check the unit for leaks per the
instructions in Section 6 (Page 12).
13. Reinstall control panel and knobs. Reinstall the rear
cover on the infrared burner housing. Reinstall
main burners, making sure to install and tighten the
nuts that retain the burners at the rear of the
burner box. Connect the unit to the electrical
supply. Light all burners one by one and verify
proper operation on high and low control settings.
See Section 6 (Page 12).
14. Reinstall radiants and grill grates.
FIGURE 10 FIGURE 11
Bottom of
unit
➞
Coupling 1/2" NPT fitting
threading compound on
these threads must be
resistant to LP gas
L.P. Regulator hose
assembly 10" W.C.
➚
➚
Type 1 Regulator
Regulator Adapter
➞
➞
➞
L.P. Tank
(Type 1)
➞
Main
Valve