Tunturi F35 - Manual (Page 4)

4
OWNER’S MANUAL
•
F30
• F35
tube into the loop in the upper part of the brake
wire outlet from the frame tube.
2. F30:
Screw the wire ends into each other.
3 . Attach the wires from the frame tube and the
handlebar support tube. Push the handlebar
support tube into place inside the frame tube.
NOTE!
The fastening screws are ready-mounted,
so please do not loosen them.
4.
Use the enclosed Allen key to tighten both
fastening screws through the holes in the tube.
NOTE !
Tighten the fastening screws by turning
them counter-clockwise. And not too tight!
5.
Pull the wire from the handlebar supprt tube
slightly upwards and loosen the fastening screw
at the end of the handlebar support tube. Insert
the handlebar into the upper end of the handlebar
support tube and fasten it by tightly screwing the
fastening screw. Be careful not to damage the
meter wire!
REAR SUPPORT
1. Place the support under the rear part of the
frame.
2. Fasten it with two hex screws and washers.
HANDLEBAR AND
HANDLEBAR SUPPORT TUBE
1. F30:
Adjust the resistance knob to position
8
.
Steer the brake wire from the handlebar support
F30_F35_05.indd 4 F30_F35_05.indd 4 1.6.2005 14:44:21 1.6.2005 14:44:21