Installing an optional sfp transceiver, Figure 3-4, Inserting an sfp transceiver into a slot – Transition Networks SM24-100SFP-AH User Manual
Page 32
3-4
Installing the Switch
3
3.
If installing a single switch only, go to “Connecting to a Power Source” at the
end of this chapter.
4.
If installing multiple switches, attach four adhesive feet to each one. Place each
device squarely on top of the one below, in any order.
5.
If also installing an RPS, place it close to the stack.
Installing an Optional SFP Transceiver
Figure 3-4. Inserting an SFP Transceiver into a Slot
The switch supports 100BASE-FX, 100BASE-BX, 1000BASE-SX, 1000BASE-LX,
1000BASE-LH and other SFP-compatible transceivers.
To install an SFP transceiver, do the following:
1.
Consider network and cabling requirements to select an appropriate SFP
transceiver type.
2.
Insert the transceiver with the optical connector facing outward and the slot
connector facing down. Note that SFP transceivers are keyed so they can only
be installed in one orientation.
3.
Slide the SFP transceiver into the slot until it clicks into place.
Note: SFP transceivers are hot-swappable. The switch does not need to be powered off
before installing or removing a transceiver. However, always first disconnect the
network cable before removing a transceiver.
Note: SFP transceivers are not provided in the switch package.
100BASE-X transceiver
1000BASE-X transceiver