Toshiba STRATA CIX - Manual (Page 105)

Telephone Button Programming
900 Series Programs
Strata CIX/CTX Telephone Button Programming 11/04
1-101
T
e
le
phon
e Butt
on
Pr
og
ramm
ing
1. Press FB01 to enable Start or Stop trace. Use the number key pad to make your selection.
2. Press Hold .
Notes
●
Start indicates the trace was previously started and is currently running.
●
Stop indicates the trace is not running and all trace buffer data was transferred to SmartMedia.
3. Press FB02 to enter trace file size. To change the setting, use the number Dial Pad.
4. Press Hold .
5. Press FB03 to set trace category. To view setting options, press the Scroll or Page button.
6. Press Hold twice to execute. Wait for the PROG = prompt to display before proceeding.
7. Enter another program number to continue programming or press
# # Hold
again to exit programming
mode.
Note When CTX 670 stops logging data, it automatically sends data to the SmartMedia card. A new trace
file is stored on SmartMedia under the
Evnttrace directory. Run the Unmount command (Program
908) before removing the SmartMedia card to ensure complete data transfer.
FB Name FB Summary Value LCD Prompt
Trace State 01 Enter
1
or
2
to Start or Stop Message
Trace. Stopping the trace outputs data to
the SmartMedia card. Wait for the
PROG=
prompt on the LCD before proceeding.
Before removing the SmartMedia card run
Program 908. See
ìFormat/Unmount
SmartMediaî on page 1-105 .
1:Start
2:Stop
1:START
2:STOP
Trace Size 02 Set the trace data size. Toshiba
recommends leaving this parameter at the
default setting which provides
approximately 15 minutes of trace data. 1~256 (in bytes)
1 unit = 16 bytes.
default = 2
SIZE=
Trace Category 03
Trace data type to be stored.
1:Call Processing
2:Maint and Admin
3:Both of the above 1.CP
2.M&A
3.CP+M&A (default)