Technicolor - Thomson XRB3059-A - Manual (Page 17)

Connecting up 04
17
En
English
Français
Deutsch
Nederlands
Italiano
Español
Using the component video jacks
Component video should deliver superior
picture quality when compared to composite
video. A further advantage (if your source and
TV are both compatible) is progressive-scan
video, which delivers a very stable, flicker-free
picture. See the manuals that came with your
TV and source component to check whether
they are compatible with progressive-scan
video.
Important
• If you connect any source component to
the receiver using a component video
input, you must also have your TV
connected to this receiver's
COMPONENT
VIDEO MONITOR OUT jacks.
1 Connect the component video outputs of
your source to a set of component video
inputs on this receiver.
Use a three-way component video cable for the
connection.
2 If necessary, assign the component video
inputs to the input source you've connected.
This only needs to be done if you didn’t connect
according to the following defaults:
• COMPONENT - 1 – DVD
• COMPONENT - 2 – TV
• COMPONENT - 3 – DVR
See Assigning the component video inputs on
page 58 for more on this.
3 Connect the COMPONENT VIDEO
MONITOR OUT jacks on this receiver to the
component video inputs on your TV or
monitor.
Use a three-way component video cable.
Connecting to the front panel video
terminal
Front video connections are accessed via the
front panel using the
VIDEO button. There are
standard audio/video jacks as well as an S-
video jack and an optical input. Hook them up
the same way you made the rear panel
connections.
• Push down on the PUSH OPEN tab to
access the front video connections.
CD CD-R / TAPE / MD FM AM USB
MCACC
SETUP MIC DIGITAL IN AUDIO R L VIDEO
VIDEO INPUT S - VIDEO
AUX
PROCESSING
This receiver
USB
L V R
VIDEO OUTPUT DIGITAL OUT
Video
camera
(etc.)
PUSH
OPEN
MCACC SETUP MIC DIGITAL IN AUDIO R L VIDEO VIDEO INPUT S - VIDEO USB
04_connecting_up.fm 17 ページ ２００６年２月２１日 火曜日 午後６時３８分