Technicolor - Thomson XRB3059-A - Manual (Page 49)

Controlling the rest of your system 11
49
En
English
Français
Deutsch
Nederlands
Italiano
Español
Selecting preset codes directly
1 While pressing the RECEIVER button,
press the SETUP button.
The remote LCD display shows SETUP .
2 Use / to select PRESET then press
ENTER .
3 Press the MULTI CONTROL button for the
component you want to control then press
ENTER .
The LCD on the remote displays the
component you want to control. 1
4 Use / to select the first letter of the
brand name of your component then press
ENTER .
This should be the manufacturer’s name (for
example,
P for Pioneer).
5 Use / to select the manufacturer’s
name from the list then press ENTER .
6 Use / to select the proper code from
the list, then try using this remote control
with your component.
The code should start with the component type
(for example,
DVD 009 ). If there is more than
one, start with the first one.
To try out the remote control, switch the
component on or off (into standby) by pressing
SOURCE . If it doesn’t seem to work, select
the next code from the list (if there is one).
7 If your component is controlled
successfully, press ENTER to confirm.
The remote LCD display shows OK .
8 Press and hold RECEIVER for about two
seconds to exit the SETUP.
Erasing all of the remote control
presets
This will erase all preset remote control preset
codes.
1 While pressing the RECEIVER button,
press the SETUP button.
The remote LCD display shows SETUP .
2 Use / to select RESET then press
ENTER .
3 Press and hold ENTER for about two
seconds .
The LCD shows OK to confirm the remote
presets have been erased.
4 Press and hold RECEIVER for about two
seconds to exit the SETUP.
Direct function
• Default setting: ON
You can use the direct function feature to
control one component using the remote
control while at the same time, using your
receiver to playback a different component.
This could let you, for example, use the remote
control to set up and listen to a CD on the
receiver and then use the remote control to
rewind a tape in your VCR while you continue
to listen to your CD player.
When direct function is on, any component
you select (using the
MULTI CONTROL
buttons) will be selected by both the receiver
and the remote control. When you turn direct
function off, you can operate the remote
control without affecting the receiver. 2
Note
1 You can’t assign the RECEIVER button.
ANALOG
ATT
SB ch SLEEP
RECEIVER SOURCE INPUT
SELECT
DVD TV DVR TV CTRL
CD FM AM RECEIVER
CD-R/TAPE USB
AUDIO/VIDEO PRE-PROGRAMMED REMOTE CONTROL UNIT
MIDNIGHT/
LOUDNESS
DIMMER SR+
+10
D.ACCESS CLASS DISC
ENTER
TV CONTROL
VOL
TUNE
TUNE
ST ST
INPUT
SELECT TV CH TV VOL
ENTER
TOP MENU
DTV MENU T.EDIT
MENU
RETURN
GUIDE
SETUP
2 You can’t use direct function with the TV CTRL function.
VSX_816.book.fm 49 ページ ２００６年２月２０日 月曜日 午後２時１４分