Thermador KBUIT4250A - Manual (Page 20)

20
L owe r L eve l i n g L e g s
NOTE: All 4 leveling legs must contact the floor to support and
stabilize the full weight of refrigerator. Rollers are for moving
refrigerator and not for permanent support.
Use socket wrench to turn leg levelers on both sides of
refrigerator to the right (clockwise) until refrigerator weight is
supported by leveling legs. The rollers should be off the floor. To
avoid cabinet damage, do not apply more than 50 in. - lbs.
(58 cm - kg) of torque to the leveling legs.
I n s t a l l C u s t o m Pa n e l s
IMPORTANT: Thermador is not responsible for the removal or
addition of molding or decorative panels that would prevent the
refrigerator from being serviced.
NOTE: To install full-overlay custom panels, refer to the
installation instructions included with the Trimless Trim Kit. See
“Design Specifications” for more information.
Door Panels
1. Remove all tape and door bracing from the refrigerator and
freezer doors.
2. Remove the screws that attach the handles to the door
frame.
3. Slide the decorative door panels into the door frames.
4. If needed, route the door panels or install a filler panel
between the doors and the decorative panels. See the
“Custom Panels” section.
5. Replace the door handles. Check to be sure that the top of
both door handles are aligned.
6. Remove the protective skin from the screw covers. Snap the
screw covers into the handle trim section.
Top Grille Panel
1. Grasp both ends of the top grille.
2. Push straight up, then pull straight out. Place the top grille
panel side down on a soft working surface.
3. Remove one end cap by loosening the nuts and sliding off the
end cap.
4. Slide the decorative panel into the top grille channel and
reattach the end caps.
1. Rear leveling legs
2. Front leveling legs
1. Panels
1 2
1 1
1. Top grille
2. Cabinet side trim
1. Bottom rail
2. Nuts 3. End cap
4. Top rail
1. Custom panel
2 2 1
3
2
1
4
1