Warning messages via the display, Appliance selfćtest, Temperature alarm – Thermador T24IF User Manual

Page 17: Door alarm, Sensor fault, Low voltage

Advertising
background image

17

Warning

messages

via the display

If several warning messages are

displayed simultaneously, deal with

each message individually.
While a warning message is

displayed, buttons cannot be

pressed.

12.

Temperature alarm

A temperature alarm is indicated by

the required temperature flashing

and the ALARM symbol coming on.

A signal also sounds if the Tone

function has been activated in setup

mode.
Cause
- Power failure
- Large quantities of fresh

produce placed in the appliance

- Fault with the appliance
Remedial action
q Press the ALARM button.

The signal stops. The highest

temperature in the appliance is

displayed for several seconds.

q Determine the cause of the

temperature alarm.

i

When the required temperature

is reached again, the ALARM

symbol goes out and the signal

stops.

Door alarm

Cause
- An appliance door has not been

closed properly or has been

open too long.

Remedial action
q Close the door.

The display goes out.

Sensor fault

Cause
- A technical defect is possible.
Remedial action
q Conduct an appliance selfĆtest.

Low voltage

The display light has gone out.
Cause
- The incoming mains voltage has

dropped below the permitted

limit value.

Remedial action
Buttons cannot be pressed. When

the mains voltage reaches the

stipulated value again, the warning

message goes out. If the warning

message is prolonged, inform your

power supply company.

Appliance

selfĆtest

Before you call customer service,

conduct an appliance selfĆtest.
q Switch off the appliance and

wait 5minutes.

q Switch on the appliance. Keep

the door closed.

5 sec.

q Simultaneously hold down the

SETUP and ALARM OFF

buttons for 5 seconds.

q The selfĆtest starts.

Different messages are

displayed in succession.

If a fault is detected during the

selfĆtest, the ALARM symbol and a

corresponding error message,

e.g. for a sensor fault, are displayed.

Inform your dealer or appliance

servicer about the error message.
If the appliance selfĆtest does not

establish any faults, the required

temperature is displayed on

completion of the selfĆtest.

Advertising
This manual is related to the following products: